User manual

Control Panel

Fig. 6

A. LED Display D. Up Button

B. MODE Button E. Down Button

C. SETUP Button

DMX Control Mode

The fixtures are individually addressed on a data-link and connected to the

controller.

The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,

the controller will display the saved DMX address the next time.)

DMX Addressing

The control panel on the front side of the base allows you to assign the DMX fixture address, which is the

first channel from which the Compact Par will respond to the controller.

Please note when you use the controller, the unit has max. 4 channels.

When using multiple Compact Pars, make sure you set the DMX addresses right.

Therefore, the DMX address of the first Compact Par should be 1(001); the DMX address of the second

Compact Par should be 1+4=5; the DMX address of the third Compact Par should be 5+4=9, etc.

Please, be sure that you don’t have any overlapping channels in order to control each Compact Par

correctly. If two or more Compact Pars are addressed similarly, they will work similarly.

For address settings, please refer to the instructions under ”Addressing’.

Controlling:

After having addressed all Compact Pars, you may now start operating these via your lighting controller.

Note: After switching on, the Compact Par will automatically detect whether DMX 512 data is received

or not.

The problem may be:

• The XLR cable from the controller is not connected with the input of the Studiobeam.

• The controller is switched off or defective, the cable or connector is detective, or the signal wires are

swapped in the input connector.

Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure

proper transmission on the DMX data link.

Display Off after 20 seconds

When no button is pressed for 20 seconds, the display will dim. The display will light up, when one of the

four buttons is pressed again.