User manual

Control Modes

FUNCTIONS:

There are 4 modes: • Select built-in programs

• Auto run (visual effects)

• Master/Slave

• DMX512 (2 or 4 Channels)

One Compact Par (Built-in Programs)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the Compact Par 7 is not connected by a DMX-cable, it functions as a stand-alone device.

Please see page 12 for more information about the built-in programs.

One Compact Par (Auto run visual effects)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the Compact Par 7 is not connected by a DMX-cable, it functions as a stand-alone device.

Please see page 12 for more information about the Auto run visual effects.

Multiple Compact Pars (Master/Slave control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. Use a 3-p XLR cable to connect the Compact Par 7x CW/WW.

The pins:

1. Earth

2. Signal -

3. Signal +

3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can

use the same functions on the master device as described on page 12 (Built-in Programs or Autorun).

This means on the master device you can set your desired operation Mode and all slave devices will

react the same as the master device.

Multiple Compact Pars (Master/Slave control)

Fig. 3