User manual

15
Ordercode: 43156
Techno Derby
3. Color Settings
01) Press the UP and DOWN buttons until the display shows .
02) Press the ENTER button to proceed. The display will show .
03) Press the ENTER button to enter the edition mode.
04) Repeatedly press the ENTER button to toggle between the following color settings:
Red color intensity
000 = OFF, 255 = Full ON
Green color intensity
000 = OFF, 255 = Full ON
Blue color intensity
000 = OFF, 255 = Full ON
White color intensity
000 = OFF, 255 = Full ON
Strobe speed
00 = OFF, 99 = Fast
05) Press the UP and DOWN buttons to adjust the settings above, as required.
06) Press the ENTER button to save the settings.
4. Strobe Shows
01) Press the MENU button until the display shows .
02) Press the ENTER button to enter the menu. The display will show .
03) Press the ENTER button to proceed.
04) Press the UP and DOWN buttons to choose one of the 18 strobe shows: .
05) Press the ENTER button to proceed to the strobe show speed settings.
06) Press the UP and DOWN buttons to adjust the strobe show speed.
The adjustment range is between , from slow to fast.
5. DMX-512 Mode
01) Press the MENU button until the display shows .
02) Press the ENTER button to enter the menu.
03) Press the UP and DOWN buttons to choose one of the available DMX channel modes:
1-channel mode
4-channel mode
04) While the display shows , press the ENTER button to proceed to the 1-channel mode.
05) Press the UP and DOWN buttons to set the DMX address between .
06) Press the ENTER button to confirm the address.
07) While the display shows , press the ENTER button to proceed to the 4-channel mode.
08) Press the UP and DOWN buttons to set the DMX address between .
09) Press the ENTER button to confirm the address.
6. Master/Slave Mode
01) Press the MENU button until the display shows .
02) Press the ENTER button. The display will show .
03) The device is now operating in Master/Slave mode. It means that it will react the same as the master
device.