User manual

9
Ordercode: 40158
XS-1 RGBW
Control Modes
There are 5 modes:
• Stand-alone (Built-in programs)
• Stand-alone (Manual)
• Sound-controlled mode
• Master/Slave mode
• DMX512 (9 or 16 channels)
One XS-1 RGBW (Built-in Programs and Manual)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the XS-1 RGBW is not connected with a DMX-cable, it functions as a stand-alone device.
Please, see page 15 and 17 for more information about the built-in programs and Manual Mode..
One XS-1 RGBW (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Turn on the music. If the device is set to sound-control, then the XS-1 RGBW will react to the music
beats. Please, see page 15 for more information about the sound control options.
Multiple XS-1 moving heads (Master/Slave control)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the XS-1 moving heads.
04) Plug the end of the electric mains power cord into a proper electric power supply socket.
The pins:
01) Earth
02) Signal (-)
03) Signal (+)
05) Link the units as shown in (Fig.03). Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on page 15 and 17 (Auto, manual or
Sound). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
Multiple XS-1 moving heads (Master/Slave control)
Fig. 03