Product guide

6
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Remove all packing materials from the Orion Chase Set. Check that all foam and plastic padding is
removed.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up Orion Chase Set
1. Fasten the effect lights onto firm trussing (Use a 30-kg rated or stronger C-clamp fastened onto the
Orion). Leave at least 1 meter on all sides for air circulation.
2. Use signal cables to connect the Orions to each other.
3. Connect the remote control to the first unit. You can control ON/OFF of the entire set with this remote.
4. Link the units as shown in (figure 4), Connect a signal cable from the first unit's "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5. Supply electric power: Plug the end of the mains power cord into proper electric power supply sockets,
starting with the first unit. Do not supply power before the whole system is set up and connected
properly.
Orion Chase Set Up
Fig. 4
Note : Link all cables before connecting electric power