Product guide

5
Description of the device
Features
The Showtec Orion Chase Set is a light effect Set with high output and great effects.
• multicoloured beams and gobo-effects
• 3 pcs. of connecting cables
• remote control ON/OFF
• music-controlled
• 4X Lamp GZ6.35 12V 100W (ordercode 80810 / 82399 / 82403). Lamps included
Overview
1
Fig. 1
1) Mountingbracket + Adjustment screw
Installation
Installing the Lamp
The Orion Chase Set uses the GZ6.35 12V 100W (ordercode 80810 / 82399 / 82403) bulb, as manufactured
by all popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Warning: Allow 15 minutes to cool down, before replacing lamp.
Procedure :
1. Loosen the 2 screws of the lamp cover.
2. Gently remove the metal housing and take out the lamp. Read lamp instructions. Do not touch the
Lamp bulb glass. (See Figure 2.). Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe
off the glass with a clean, lint-free towel and rubbing alcohol.).
3. Insert the lamp pins into the small holes in the lamp socket.
4. Put the housing back and fasten the screws snugly
Fig. 2