Instruction Manual
3/10 8/10
MENU Enter Down Up
LED Zoom Profile Light
Power Input
Power to the
next fixture
DMX signal to
the next fixuture
Power cable
DMX signal cable
AC100~240V
50-60Hz
DMX сontroller
LED Zoom Profile Light
4.Wiring Diagram
5.Control Board
Adjust the key setting function on the
control panel
Press“MENU”--->Display first -level menu--->
Press“Enter”--->Display second-level menu--->
Press“Down”&“Up”to adjust relevant function->
Press“Enter”and“MENU”to quit current menu
Press“Enter”---> To next first-level menu.
9.Technical Specifications
LED Source
Beam Angle
Control
DMX Channels
Connection
Voltage
Working
Temperature
Power
Consumption
Dimensions
(LxWxH)
Weight
COB 60W LED 4 IN 1, RGBW
Indoor,IP20.
-20℃-40℃(-4°F-104°F)
60W
35.2X17.8X15.8cm
4.3Kg
Manual Zoom 13-25° with hight- efficiency optical system
1.DMX512 2.RDM 3.Master/Slave Operation
11CH/6CH
PowerCON IN & OUT; 3-Pin DMX In& Out(5 -Pin DMX available)
Electronic full-range AC 100-240V 50/60Hz
10.Please Note:
2 ColorTemp.《 》
ColorTemp [MODE]
9928K
>
>
TEMPERATURE 28℃
OFF
>
>
TEMPERATURE 28℃
ColorTemp [MODE]
Master/Slave Mode, Colortemp(CCT)adjustable from 1800K to 9928K
As show below①②,factory setting as below 。
(If the Colortemp function is enabled, the R G B W function cannot be used alone.
If you want to use the RGBW function alone, you must turn off Colortemp).
ColorTemp [MODE]
1800K
>
>
TEMPERATURE 28℃
① ②
3
3
1.《Dimming、Brightness Function》
Before using the fixture,you should check whether (Dimming,brightness function) is
turned on ,As shown in figure ;the factory setting is on .This function should be ①
checked when the fixture does not turn on when
the lamp is turned on.It is not affected by this function
in DMX mode
Dimming
[255]
①