Specifications

Hardware Installation Chapter 1:
4
1.2.1.4 Physical Installation
The 4500 device is designed for desktop, rack or wall-mount installation. Observe the
following guidelines when installing the system:
• Always verify that the AC cord is disconnected from a power source prior to
installation.
• Ensure that the installation site has adequate air circulation and meets the minimum
operating conditions for the system as specified in Specifications of this document
Required Tools and Materials
• If the unit will be mounted on the wall:
— 1 Flat or Philips screw driver
— 2 round or flat head Philips or slotted screws – 1 ½ inch long
F
Erase –
• If pressed twice in quick succession,
the CLI password will be changed to
its original password.
• If pressed three times in quick
succession, the 5300 will revert to
factory default settings. All passwords
will be reset and all prior
configurations will be erased.
Note: The default LAN address will be
set to 192.168.1.1
Caution: Setting the system
configuration to factory default will
erase all configuration changes.
G
Link Speed LED
Off – If the link is up, it indicates that the port is connected
to a 10BaseT Ethernet switch or hub.
Solid Amber – Indicates that the port is connected to a
100BaseT Ethernet switch or hub.
H
Link Status LED
Solid Green – Ethernet link is up.
Blinking Green – Indicates activity on the link.
Call out Description