Installation guide

452 Planning and Installation Guide ShoreTel 14.2
ShoreTel Voice Switches ShoreTel E1k Voice Switch
F
Figure 88: ShoreTel E1k Front Plate
Switch Capacity
 Digital Circuit Resources: 30 channels maximum

One E1 circuit, 30 channels per circuit
 Make Me Conference Resource: None
 Maximum IP Phone Resources: None
LED Descriptions
Power LED
The ShoreTel E1k has one power LED, which indicates the following:
 On: The switch is operating normally.
 Off: The switch has no power.
 Flashing

2 flashes — The switch failed its internal self-test. This indicates a hardware failure; replace
the unit and submit a Return Material Authorization (RMA) to ShoreTel, Inc.

3 flashes — Booting via FTP. Flash memory might be corrupted. Go to the Quick Look page to
ensure that the system is running properly.

4 flashes — The IP address is unavailable. DHCP and BOOTP did not respond to the IP
address request, and the IP address is not available in nonvolatile memory to continue boot
process. The switch will automatically reboot in five seconds and try again. Check the BOOTP/
DHCP server and the network configuration to ensure that the voice switch is receiving a valid
IP address.
Default
Switch
Audio Output Port
(night bell)
Power
LED
Network
LEDs
LAN 2
Connector
RS-232C
Maintentance
Port
Status
LED
Audio Input Port
(music on hold)
Network
LEDs
E1 LEDs
LAN 1
Connector
Monitor
Port
Telc o
Port