Installation guide

ShoreTel 30 Voice Switch ShoreTel Voice Switches
F
ShoreTel 14.2 Planning and Installation Guide 429
ShoreTel 30 Voice Switch
The following sections describe ShoreTel 30 resource capacity, LED behavior, and connectors. The
ShoreTel 30 is not supported in installations outside the U.S. and Canada. Figure 82 displays the
ShoreTel 30 front plate.
Figure 82: ShoreTel 30 Front Plate
Switch Capacity
 Analog Circuit Resources

Ports 1-2: Two Loop Start Trunks

Ports 11-12: Two Extensions or DID Trunks. A single command configures all ports as either
Extensions or DID trunks.

Power Failure Transfer Unit: Trunk Port 1 to Extension Port 12
 Make Me Conference Resources: none
 Maximum IP Phone Resources: none

Analog Port Reallocation: 20

Built-in Resources: 10
LED Descriptions
Power LED
The ShoreTel 30 has one power LED, which indicates the following:
 On: The switch is operating normally.
 Off: The switch has no power.
Default
Switch
Audio Output Port
(night bell)
Power
LED
Network
LEDs
LAN 2
Connector
RS-232C
Maintentance
Port
RJ-21X
Telco Port
Status
LED
Audio Input Port
(music on hold)
Network
LEDs
LAN 1
Connector