Installation guide

Displaying Settings for a ShoreTel IP Phone IP Phone Installation
14
ShoreTel 14.2 Planning and Installation Guide 277
The Admin Options menu opens.
4. Use the navigation key pad and the selector button to open the submenus necessary to configure
parameters as follows:
 If you are not using a DHCP server to provide an IP address, enter the following information:

Internet protocol > Use DHCP (Toggle to Off.)

Internet protocol > IPv4 address (Enter the static IP address of the phone.)

Internet protocol > Subnet mask (Enter the static IP subnet mask of the phone.)

Internet protocol > Gateway (Enter the static IP gateway.)

Internet protocol > SNTP server (Enter the IP address of the time server.)
 If you are not using DHCP to provide configuration parameters, enter the following information:

Services> Config server (Enter the IP address of the ShoreTel configuration server.)
For descriptions of these parameters, see Table 65 on page 276.
5. With the appropriate submenu highlighted, do one of the following:
 On the IP420, press the selector button on the navigation key pad.
 On the IP480, IP480g, and IP485g, press the Edit soft key.
6. To return to the previous menu, do one of the following:
 On the IP420, scroll down to the Back option and press the selector button on the navigation
key pad until you return to the top-level menu.
 On the IP480, IP480g, and IP485g, press the Back soft key until you return to the top-level
menu.
7. To apply the changes, do one of the following:
 On the IP420, with Exit highlighted press the selector button on the navigation key pad.
 On the IP480, IP480g, and IP485g, press the Apply soft key.
The phone reboots and applies settings.
Displaying Settings for a ShoreTel IP Phone
You can display information about a ShoreTel IP phone by entering a key sequence on the phone’s key
pad.
Tip
On IP480, IP480g, and IP485g phones, to exit the menu and apply changes, press and hold
the Back soft key for 2 seconds.