Installation guide
274 Planning and Installation Guide ShoreTel 14.2
IP Phone Installation Manual Configuration at Bootup
14
3. At the Clear All Values prompt, press # (No).
4. At each prompt, enter the appropriate value listed in Table 64 on page 274.
5. Press # to advance to the next setting or * to exit.
6. To accept changes, press #.
The boot process begins after you finish entering new values or accepting existing values. The
phone downloads the latest firmware from the ShoreTel server and in the process, reboots several
times. When the phone displays the date and time, the boot and upgrade process is complete.
See the Maintenance Guide for details about upgrading the phone’s firmware.
On ShoreTel 400-Series IP Phones
1. Connect the Ethernet cable to the data jack on the back of the IP phone.
2. As the phone is booting, when prompted press any key to enter setup.
3. At the Admin Password prompt, enter the default password 1234 or the password provided by
your system administrator.
Note
The default password is set in ShoreTel Director. For more information, see the ShoreTel System
Administration Guide.
Table 64: Configuration Values for ShoreTel 100-, 200-, 500-, and 600-Series IP Phones
Prompt Value
DHCP – Press * to toggle to the “Off” position, and then press #.
FTP – Enter the IP address of your ShoreTel server, and then press #.
MGC – Press #. (The phone obtains the address from configuration files on the ShoreTel
server.)
SNTP – Enter the IP address of your time server, and then press #.
802.1Q Tagging – Off Press #. (Consult your network administrator before changing this value.)
VLAN ID – Press #.
Country – Enter the country code (see Table 15 on page 56).
Language – Enter the language code (see Table 16 on page 57).
Save all Changes Press #. (Yes)
Note
This password is configured through ShoreTel Director in the Administration > IP Phones >
Options page. The parameter name is IP Phone Password. If the phone uses factory defaults, the
phone has never been connected to a server, and you have not modified the IP Phone Password,
use the default password, 1234.