Installation guide

262 Planning and Installation Guide ShoreTel 14.2
Installing ShoreTel Voice Switches ShoreTel Director Switch Configuration
13
11. Power on the virtual machine.
12. Open the console on the virtual switch you want to configure and log in with the following
credentials:
 User ID: root
 Password: ShoreTel
13. Enter the DHCP and server IP information that the server will use to download firmware updates.
14. Restart the virtual switch.
The updated firmware begins downloading and installing automatically. After the firmware upgrade
completes, the virtual machine reboots automatically.
15. When the virtual switch comes back online, open its console and log back in using root/ShoreTel.
16. To open the ShoreTel parameters screen, enter stcli.
17. On the ShoreTel parameters screen, note the values for IP address and MAC address. Save these
values for configuring the virtual switches in Step 18.
18. Configure the virtual device.
 To configure virtual switches, see Chapter 5, Configuring Voice Switches, in the ShoreTel
System Administration Guide.
 To configure virtual Service Appliances, see Chapter 6, Configuring the Service Appliance, in
the ShoreTel Conferencing and Instant Messaging Planning and Installation Guide.
ShoreTel Director Switch Configuration
To complete the installation, configure the ShoreTel voice switches with ShoreTel Director. For more
information, refer to Chapter 5, Configuring Voice Switches, in the ShoreTel System Administration
Guide.
Note
You can only increase the disk size before you power on the virtual machine. If you need to have
more disk space for conference recording, you must change it before you power on the virtual
machine.