Specifications

Chapter 4: Voice Calls ShoreWare Call Manager Manual
ShoreTel 9 61
• To terminate a conference call, either hang up the entire conference or individually
terminate call connections with conference participants, as described in Section
4.7.1.2.
4.7.1.1 Adding Calls to a Conference
Three Call Manager operations adds participants into a conference call: specifying new
participants, joining two calls, and a guided addition of a new call.
Specifying New Participants
Your specifying new participant through a Conference panel, shown in Figure 4-21.
To specify a new participant through the Conference panel:
Step 1 Verify the selected voice call is in the connected state.
Step 2 Open the Conference panel by performing one of the following:
• Click the Conference button on the call cell.
• Right click the call cell and select Conference
• Select Call -> Conference from the main menu.
• Click the Application Button and select Call -> Conference.
• Press Ctrl+J
Step 3 Begin entering the contact name or number in the data entry field of the
Conference panel.
The table displays a list of directory entries filtered by data entry field contents.
Step 4 Either select a contact in the table or complete the number in the data entry field.
The Dial Digits field, located above the buttons at the bottom of the panel, lists the
contact's number after you select a table entry
Step 5 Press the button at the bottom of the panel that corresponds to your desired
Conference consultation type.
Figure 4-21 Conference panel