Specifications

Configuring Switches
6 – 20 ShoreTel, Inc.
Network LEDs
The ShoreGear-Teleworker (IPBX-TW) network LEDs indicate the speed at which the
switch is communicating with the network and whether there is network activity.
The network LED descriptions are as follows:
ShoreGear-T1 and ShoreGear-E1 Voice Switch
The ShoreGear-T1 (Figure 6-9) provides higher-density trunking to the central office
using T1 or PRI signaling. The ShoreGear-E1 provides higher-density trunking using
E1 PRI signaling.
The ShoreGear-T1 and ShoreGear-E1 can also be used as a gateway to legacy PBX
systems.
The ShoreGear-T1 and ShoreGear-E1 LEDs are defined below. For information about
the connectors, please see the ShoreTel 6 Planning and Installation Guide.
Figure 6-9 ShoreGear-T1 and ShoreGear-E1 LEDs
10M When lit, this LED indicates that the switch is connected to a 10BaseT
network.
100M When lit, this LED indicates that the switch is connected to a 100BaseT
network.
Traffic This LED indicates total network activity, as follows:
• When flashing, network activity is detected.
• When on (not flashing), heavy network activity is detected.
• When off, no network activity is detected.
NOTE If you have three switches that are connected to the same hub, and
one switch’s Traffic LED shows activity, the other switches will
indicate the same.
Network LEDs
T1 LEDs
Power LED