Specifications

Maintenance
ShoreTel 6.1 Administration Guide 16 – 9
The following is the link performance information for the ShoreGear-T1 and
ShoreGear-E1:
Ports Section
Each Switch Maintenance page has a Ports section, where the configured ports are
shown. The Ports section shows the port number, port description (first and last name
or trunk name), usage state, service state, and available commands. Refer to Figure 16-
7.
The following are the port Usage states:
The following are the port Service states:
Signal States: OK, Bipolar Violations, Loss of Signal,
Unknown
Framing States: OK, Yellow Alarm, Bit Error, Out of Frame,
Unknown
Line Loopback States: Off, On, Unknown
Commands: Turn On, Turn Off
Payload Loopback States: Off, On, Unknown
Commands: Turn On, Turn Off
Error Free Seconds The number of error-free seconds that occurred in the
last 15 minutes and 24 hours.
Errored Seconds The number of errored seconds that occurred in the last
15 minutes and 24 hours.
Severely Errored Seconds The number of severely errored seconds that occurred in
the last 15 minutes and 24 hours.
Unavailable Seconds The number of seconds the server was not available.
Bit Error Rate Not used.
Out of Frame The number of times the link has been out of frame in
the past 15 minutes and 24 hours.
Unknown The state is unknown, likely because communication
between the server and the switch has been lost.
In Use The port has at least one active call.
Off Hook The port is off-hook and has no active calls.
In Service
(green arrow up)
The port is in service.