Specifications

Managing Remote Access Configuring General Settings
6
ShoreTel Mobility Router Administration Guide 47
Configuring General Settings
After setting up your network, as described in “Before You Begin” on page 42, configure general
settings for remote access:
Ethernet interface used for remote access
Virtual IP address of the cluster (only if you have created a redundancy cluster)
Public NAT information
External IP address
UDP port
TCP port
Tunnel interface MTU
Remote client IP lease duration
To configure general settings:
1. Select Configuration > System > Networking > Remote Access. The Remote Access page
displays with the General tab active. The following screen displays example settings:
2. To enable remote access, make sure the Enable check box is selected. By default, this check box
is not selected. To disable remote access, clear the Enabled check box.
3. In the Remote Access IP Interface list, select the Ethernet interface used for remote access.
Typically, this is the eth1 interface.
4. Do one of the following:
If you do not have a redundancy cluster enabled, go to step 6.
If you do have redundancy cluster enabled, go to step 5.