Specifications

Configuring Network Settings Configuring Ethernet Interfaces
5
ShoreTel Mobility Router Administration Guide 33
5. Verify the interface speed. The default and recommended value is Auto. To change the speed,
select one of the following in the Speed list:
 10—10 Mbps (This option is not supported if you are going to create a redundancy cluster. For
information about redundancy clusters, see “Managing Redundancy Clusters” on page 227.)
 100—100 Mbps
 1000—1000 Mbps
 Auto—Speed is auto-detected
6. Verify the duplex value. The default value is Auto. To change the duplex setting, select one of the
following in the Duplex list:
 Full—Full-duplex
 Half—Half-duplex
 Auto—Auto-detect duplex setting.
7. Review the MTU value.
8. Verify the MAC address.
9. Review the online Status of the Mobility Router.
10. To save your changes, click Apply.