Specifications

Configuring Network Settings Configuring Ethernet Interfaces
5
ShoreTel Mobility Router Administration Guide 32
Configuring Ethernet Interfaces
After specifying the basic Ethernet interface in the Initial Configuration Wizard or completing the
Hostname/DNS tab (“Configuring Hostname and DNS” on page 31), you can configure the following
settings for each Ethernet interface (eth0, eth1):
 Interface speed
 Duplex settings
Some information in the fields under the Interface menu reflect the responses provided during the
Initial Configuration Wizard setup. Some fields are set to system defaults that generally do not require
changing.
Figure 18: Interface
1. Select Configuration > System > Networking > Interface. The Interface page displays. The
eth1 tab is active.
2. Verify that the interface is enabled. For the eth0 interface, this check box is selected by default and
cannot be changed. You can enable or disable the eth1 interface.
3. Verify the IP address. To change the IP address, select one of the following:
 Use DHCP—If you entered N in response to the Use DHCP on eth0 interface prompt in the
Initial Configuration Wizard, you can change eth0 to DHCP by selecting this field and then
selecting Apply.
 Static— This field defaults to the IP address entered in the Primary IP Address field entered in
the Initial Configuration Wizard and should not be changed.
4. In the Gateway field, verify the gateway value. This value defaults to the IP address provided
during the Initial Configuration Wizard and should not require changing.