Specifications

Configuring System Settings Configuring NTP
3
ShoreTel Mobility Router Administration Guide 14
Configuring NTP
If you configure the Mobility Router to get the system date and time from an NTP server, NTP polls the
specified server at regular intervals and updates the system date and time so that they are
synchronized with the server. By default, NTP is enabled. A default NTP server has already been
defined. You can add other NTP servers.
7. Click OK to log out. A message confirming that you have logged out displays in the browser.
Enabling NTP
To enable NTP:
1. In the Administration Portal, select Configuration > System > Date and Time > NTP. The NTP
page displays.
2. To enable NTP, select the Enable NTP check box. To disable NTP, clear the Enable NTP check
box. By default, NTP is enabled.
3. To save your changes, click Apply.
Adding NTP Servers
If you do not want to use the default NTP server that is defined, you can add NTP servers. If you add
multiple NTP servers, the Mobility Router contacts the first NTP server listed alphabetically to get NTP
information. If that server is unavailable, the Mobility Router uses the alphabetical list of NTP servers
to contact another server until a connection is made.
To add an NTP server:
1. In the Administration Portal, select Configuration > System > Date and Time > NTP. The NTP
page displays.
2. To add a new NTP server, click Add. The Add NTP Server page displays.
Note
NTP is enabled, the Mobility Router reads the time from the NTP server, not the time set manually.
The manual date and time settings are ignored.