Specifications

Managing IP-PBX Integration Configuring SIP Trunk Settings

ShoreTel Mobility Router Administration Guide 121

Configuring SIP Trunk Settings

To configure SIP trunk settings:

Figure 51: SIP Trunk Parameters

1. In the Name field, type the name of the trunk. By default, a name is provided. It is the name you

specified on the General tab, with -trunk appended to the name. The name can be up to 50

alphanumeric characters and can contain spaces, hyphens (-), and underscores (-).

2. In the Description field, type a description for the trunk. By default, a name is provided. It is based

on the name that you specified on the General tab, with trunk appended to the name.

3. In the Local SIP End Points area:

a. Verify the value of the eth0 Interface, as shown on the Interfaces page. This IP address is

also entered as the destination IP address when you configure the SIP trunk on the IP-PBX.

b. Check Use Alternate IP Address if your network topology requires you to use a different IP

address for the trunk connection than the interface default address. For most deployments this

is unchecked.

c. In the Port field, type the port number of the trunk-side port on the Mobility Router. Use the

same port number as the destination port in the IP-PBX SIP trunk configuration. The default is

5068.

d. In the SIP Domain Name field, type the appropriate local domain name.

4. In the Remote SIP End Point area, type the fully qualified domain name (FQDN) or IP Address of

the IP-PBX being added. If the IP-PBX has more than one IP address, make sure that the IP

address added here is the local SIP address on the IP-PBX being configured.