Specifications

Installing ShoreGear Voice Switches
16 – 6 ShoreTel, Inc.
Ethernet environment, and that the switch is receiving and transmitting
data.
Step 7 Refer to the ShoreTel 6 Administration Guide to configure the ShoreGear
voice switch according to your site’s requirements.
Step 8 Connect your T1 line to the Telco port.
ShoreGear-E1 (IPBX-E1) Rack Mount Instructions
The ShoreGear voice switches are supplied with two brackets for mounting the unit in
a 19-inch rack.
To mount the switch in a rack, follow these steps:
Step 1 Attach the two mounting brackets to the ShoreGear voice switch with
the screws included with the unit.
Step 2 After installing the mounting brackets, use standard screws to mount
the switch in the rack.
RJ-21X Cable Retainer Installation
A cable retainer for the RJ-21X port is included with the ShoreGear-40/8, ShoreGear-
60/12, and ShoreGear-120/24. The retainer consists of a metal bracket with a velcro
strap.
To install the retainer:
Step 1 Using a number 1 Phillips screwdriver, remove the two black Phillips
head screws on either side of the RJ-21X port.
Step 2 Place the retainer in the recessed area around the RJ-21X port.
Step 3 Reinstall the two screws.
Step 4 Plug in the RJ-21X cable.
Step 5 Pull the velcro strap tightly around the connector on the RJ-21X cable,
and fasten it.
ShoreWare Director Switch Configuration
To complete the installation, you need to configure the ShoreWare voice switches with
ShoreWare Director. For more information, see the ShoreTel 6 Administration Guide.
Adding a ShoreGear-120/24, ShoreGear-60/12, or ShoreGear-40/8
To add a new ShoreGear-120/24, ShoreGear-60/12, or ShoreGear-40/8 switch to the
ShoreTel 6.1 system, or to edit an existing switch configuration:
Step 1 Log into ShoreWare Director and click Switches from the navigation
frame.