Specifications

Planning Applications and Services
Planning and Installation Guide 11 – 13
Step 16
Click Save to store your changes.
NOTE This configuration assumes multiple analog ports will be used
to connect the switch to the fax server. If only one fax server port will
be used to connect to the fax server, then the call forwarding must be
set to Never. Similarly, if this port is the last one in a chain of ports
dedicated to the fax server, then the call forwarding must be set to
Never.
If you are using multiple analog switch ports to connect to the fax server you must
specify the first redirect extension in that chain. (This is the site's fax redirect
extension.)
Step 17 Under the Administration link, click Sites.
Step 18 Click on the site where the switch and fax server are located (i.e. either
Headquarters or Remote).
Step 19 Under FAX Redirect Extension (near the bottom of the Site window),
enter the extension associated with the first port in the chain of fax
server ports. (This is the first place incoming faxes will be sent.)
Figure 11-5 Configuring Fax Redirect extension for primary fax server port
Step 20
Click Save to store your changes.