Specifications

Diagnostics Chapter 4: ShoreGear Switches
60
cliStart Opens the ShoreTel command line interpreter (from a
Telnet session) from serial ports only.
You must reboot the switch
to return to the VxWorks
interface.
config_status Outputs the configuration records for the switch.
DEBUG_LEVEL Sets the ShoreSIP debugging flags. Recommend using level
0xe00.
diagdCommands Outputs full switch diagnostic information.
dial_num_dump Displays information about switch's off-system
extension configuration.
dn_plan_status Displays information about the switch's dial plan.
dnp_debug_level Displays detail information (digit by digit) about dial
plan access.
Recommend using level 1.
dtmf_debug Displays RFC2833 for G729 related events. Values can be 0 or 1 (default
is 0).
DumpSB Displays maximum PMCSW outputs.
DumpSRAM Displays Motorola 860 processor information. For IPBX model switches
only.
dumpUsedBw Displays information about actual bandwidth used on
individual calls/legs.
etherMonBroadcast Writes the ethernet broadcast messages to a .cap file in
\inetpub\ftproot directory of the ShoreWare server that
are not intended for that switch.
Recommend using level 1.
etherMonDump Writes the ethernet trace information captured when
using EtherMonStart. Writes to a .cap file in
\inetpub\ftproot directory of the ShoreWare server
controlling the switch. The .cap file name is ST-<lst 3
bytes of MAC-time-date>.cap.
etherMonStart <bytes> Bypes is the number of bytes of information you want
to capture (for example, 10000000). Captures ethernet
packets for trace purposes
This command consumes
memory on the switch. Use
memShow to determine
available memory and never
specify more than is
available.
etherMonStop Stops capturing ethernet packets.
eval_adm_var Displays information about switch's own bandwidth
usage.
eval_bwm_var Displays information about total and available
bandwidth.
ext_bca_status Displays active BCA calls along with call stack usage
information.
To be run on switches
hosting BCA extensions.
ext_cco_status Displays information the switch's extension CCOs.
ext_conf_status Displays MakeMe conference port status.
ext_debug_level1 Logs extension CCO configuration.
ext_debug_level Sets the extension debugging level. Recommend using level 4.
ext_pg_status Displays active pickup group calls. To be run on the switches
hosting PG extensions.
Command Description Notes
Table 4-5 VxWorks CLI Commands