Specifications

Maintenance Chapter 4: ShoreGear Switches
56
0x42040
aggregates the flags “0x40 + 0x2000 + 0x40000” and instructs the switch to use DHCP to
get boot parameters, disable the ShoreTel shell, and set network speed and duplex mode to
100 Mb HD.
Setting IP Address and Boot Parameters from the VxWorks Boot Monitor
If you are unable to access the ShoreGear CLI, you can access the same configuration
options available with the bootChange command from the switch’s boot monitor.
WARNING Making the incorrect settings in the boot monitor can cause the switch to
malfunction.
To access the boot monitor:
Step 1 Connect a serial cable between a personal computer and the ShoreGear switch.
Step 2 Use a terminal emulation program such as HyperTerminal to open a connection
to the switch.
Step 3 Apply these values to the terminal settings:
• Speed: 19.2 kbps
• Data bit: 8 bits
• Stop bit: 1
• Parity: No parity
• Flow Control: None
Step 4 Ty p e
c at the prompt and press ENTER. You will be guided through the
options listed in Table 4-1 on page 55.
4.2.3 ShoreGear Switch Configuration Reset
Each switch has a hidden reset button on the front panel that restores the switch to factory
default boot settings and requests a new configuration from TMS. To enable the reset, press
the button for 5 seconds. This button reboots the ShoreGear voice switch.
This completely clears all boot parameters and clears the switch’s configuration.
Command Description
0x0 Network speed and duplex mode auto-negotiate.
0x20 Disable login security.
0x40 Use DHCP to get boot parameters.
0x1040 Use bootp to get boot parameters.
0x2000 Disable ShoreTel shell.
0x10000 Network speed and duplex mode 10 Mb full duplex (fixed).
0x20000 Network speed and duplex mode 10 Mb half duplex (fixed).
0x30000 Network speed and duplex mode 100 Mb full duplex (fixed).
0x40000 Network speed and duplex mode 100 Mb half duplex (fixed).
Table 4-2 Boot Flags