Specifications

Maintenance Chapter 4: ShoreGear Switches

Step 2 Use a terminal emulation program such as Tera Term Pro freeware to open a

connection to the switch.

Step 3 Apply these values to the terminal settings:

• Speed: 19.2 Kbs

• Data bit: 8 bits

• Stop bit: 1

• Parity: No parity

• Flow Control: None

The CLI Main Menu

The CLI main menu automatically appears at system startup. You can also invoke the menu

at any time by entering a question mark (?).

The following list describes the commands available in the CLI main menu:

• (1) -- Show version: Lists version numbers for firmware and boot ROM in addition

to the base version and the CPU board version.

• (2) -- Show system configuration: Displays the switch’s boot and IP configuration.

• (3) -- Change system configuration: Takes you to the system configuration menu

where you can set a switch’s boot and IP configuration.

• (4) -- Reboot: Reboots the switch.

• ? -- Help: Enter a ? to print this menu.

To select an option in Shoregear CLI, enter the number associated with the menu item and

press ENTER. To change or set a parameter, select the item you wish to change, then type

the parameter number and press Enter.

Boot and IP Configuration Options

When you choose Change System Configuration from the CLI main menu, a menu of boot

and IP configuration options appears.

• (0) -- Return to previous menu:

• (1) -- Change IP address:

• (2) -- Change IP subnet mask:

• (3) -- Change gateway IP address:

• (4) -- Change server IP address: This is the IP Address the ShoreWare server with

the FTP service for the switch.

• (5) -- Change boot method:

• (6) -- Enable/disable DHCP:

• (7) -- Change network speed and duplex mode:

• ? -- Help:

After you have set your IP address and boot options, enter ? to return to the main menu.

You must reboot the switch for the new setting to take effect.