Install guide

6
2b Connect to power & network
(Non-powered Ethernet network requires AC power adapter)
Connect the AC power
cable between the adapter
and an electrical socket.
c
Connect the second network
cable to the DATA IN (or
NETWORK) port on the
adapter and an Ethernet
jack in the workspace (or on
a data switch/router).
b
Connect a network cable
to the DATA & POWER
OUT (or PHONE) port on
the adapter. The other end
goes to the LAN port on
the button box.
a
Upper LED lights
green to indicate
when phone is
connected and
using power.
BB24 (button box)
IP 560 phone
Ethernet wall jack
Note: The button box can forward power to an IP phone but an IP phone cannot
forward power to a button box. Thus, if two devices will be daisy-chained, the
button box must be the first device in the chain.
Lower LED
lights green to
indicate adapter
has AC power.