User guide

12 Base Station and Repeater User Guide ShoreTel IP Phone 930D
Using the Base Unit Resetting the Base to Factory Defaults
1
Resetting the Base to Factory Defaults
To return a base to its factory defaults, follow this procedure:
1. Plug in the base and wait until the LED indicator starts flashing green.
2. Press and then hold the reset button on the back of the base for at least 10 seconds, or until the
LED indicator turns off.
The base restarts using its factory defaults.
Monitoring a Base with the LED Indicator
The base has an LED indicator on the front that can be used to monitor the base’s status. Additional
information on the base status is available using ShoreTel IP930D Manager.
WARNING!
Never unplug a base or perform any type of reset on a base whose LED indicator is fast
flashing red (500 mS on/500 mS off); doing so can permanently damage the base. A fast red
flash means that firmware in the unit is being upgraded.
LED State Description
Off No power.
Two red flashes followed by flashing green (1 sec
on/1 sec off)
Base is starting.
Winking green (800 mS on/200 mS off)
Basehasstartedrunningbuthasnotyet
synchronizedtoamaster(multicellonly).
Solid green Unit is operating normally and is synchronized
to a master.
Winking red (800 mS on/200 mS off) No Ethernet.
Fast flashing red (500 mS on/500 mS off) Unit is upgrading firmware.
(Do not remove power.)
Flashing red/green (1 S red/1 S green) Registration enabled.
Solid red Critical error.