Installation guide
IP8000 Conference Phone Application Note—Page 5
This selection brings up the “Trunk Groups” screen (Figure 8).
From the pull down menus on the “Trunk Groups” screen select the “site” desired and then select “SIP” and click on the
“Go” link. The “Edit SIP Trunk Group” screen” will appear (Figure 9).
Figure 8 – Trunk Groups Settings
Figure 9 – SIP Trunk Group Settings
In the “Edit SIP Trunks Group” screen, input a name for the
trunk group.
Determine whether the trunks need to be congured as
inter-site trunks (trunks between sites) or intra-site trunks
(trunks within a site). The next step is to choose the setting
of the “Teleworkers” check box.
By NOT checking Teleworker no bandwidth usage will •
count against the site and the Intra-Site codec will be used
when calls are made Intra-Site.
If the Teleworker checkbox “is” enabled then the call will •
be counted against the allocation of bandwidth and the
Inter-Site codec will be used.
Should Teleworker not be checked and the call goes from •
San Jose (location of the SIP Trunk) to another site in NY
then Inter-Site will apply.
Note: The location of the SIP Trunk NOT the IP8000 is what
is used to determine the location of the call.