Installation guide
IP8000 Conference Phone Application Note—Page 4
Switch Settings - Allocating Ports for SIP Trunks
The nal general settings to congure are the ShoreGear
switch settings. These changes are modied by selecting
“Administration” then “Switches” in ShoreWare Director
(Figure 5).
Each Check box designated as a SIP trunk enables support
for 5 individual trunks.
ShoreTel System Settings - Trunk Group
ShoreTel Trunk Groups support both Dynamic and Static SIP
end point Individual Trunks.
Note: A ShoreGear switch can only support one Trunk
Group with Dynamic IP addressing.
The settings for Trunk Groups are changed by selecting
“Administration” then “Trunks” followed by “Trunk Groups”
within ShoreWare Director (Figure 7).
Figure 5 – Administration/Switches
This action brings up the “Switches” screen. From the
“Switches” screen simply select the name of the switch to
congure. The “Edit ShoreGear …Switch” screen will be
displayed. Within the “Edit ShoreGear …Switch” screen
select the desired number of SIP trunks from the ports
available (Figure 6).
Figure 6 – ShoreGear Switch Setting
Figure 7 – Administration /Trunk Groups