Installation guide
IP 8000 Conference Phone Application Note—Page 2
already been congured on the system, skip this section and
go on to the “Creating User Extension for SIP device”
section of this document.
Call Control Settings
The Call Control Options within ShoreWare Director may
need to be recongured. To congure these settings for the
ShoreTel system, log into ShoreWare Director and select
Administration, Call Control and then Options (Figure 1).
The “Call Control / Options” screen will then appear (Figure 2).
ShoreTel Configuration
This section describes the ShoreTel system conguration to
support the IP 8000. The section is divided into general
system settings and individual user conguration needed to
support the conference phone.
Note: If you have upgraded from a previous version of
ShoreTel and you had the IP 8000 conference phone
already congured in a SIP Trunk environment, follow these
next steps, otherwise go on to the “ShoreTel System
Settings – General” section:
Using ShoreWare Director, navigate to “Administration”, •
then “Trunks…”, followed by “Individual Trunks”.
Delete ALL of the individual trunks that are currently in use •
by the IP 8000 conference phone.
If you plan on using the extension number currently •
assigned to the IP 8000, navigate to the SIP “Trunk
Group” for the IP 8000 and edit the Off System Extension
(OSE) range, to either delete the extension number or edit
the range to exclude the number.
Note: If you don’t plan on using the SIP “Trunk Group” any
longer you may choose to delete it. Keep in mind that if
any “User Groups” are currently utilizing it, you will rst
need to remove access to the “Trunk Group” before you
can delete it.
ShoreTel System Settings - General
If this is a new deployment of the IP 8000, the rst settings
to address within the ShoreTel system are the general
system settings. These congurations include the call
control, the switch and the site settings. If these items have
Figure 1 – Administration Call Control/Options
Figure 2 – Call Control/Options