Specifications

ShoreTel Voice Switches VxWorks® Command Line Interface
3
ShoreTel 14 Maintenance Guide 76
Commands Available Through VxWorks
®
CLI
Tab l e 11 on page 76 describes the commands available through the VxWorks
®
interface.
Note
ShoreTel does not support changing or setting IP or other parameters using the VxWorks
®
interface.
Changes made using this interface may not be persistent, and using it may cause unpredictable
behavior in the system.
Table 11: VxWorks
®
CLI Commands
Command Description
Available on
Voicemail-Enabled
Switches
Notes
adm_debug_level Logs admission control and
bandwidth manager signal
flow onto serial port.
– 2 logs more
diagnostics.
adm_diag_level Logs admission control and
bandwidth manager signal
flow into IPBX log.
– 2 logs more
diagnostics.
arpShow and arptabShow Displays the ARP table. X
autoReboot – 0 Turns the switch watchdog off
to prevent rebooting after a
catastrophic failure.
Use only as directed by
ShoreTel Technical
Support.
bigNvRamSetup Erases switch's configuration
in NvRam.
bootChange Changes the boot ROM
parameters.
Use with caution.
cid_debug_level Logs caller ID related
information for extensions.
cliStart Opens the ShoreTel
command line interpreter
(from a Telnet session) from
serial ports only.
X Switch reboot required
for returning switch to
VxWorks
®
interface.
config_status Outputs the configuration
records for the switch.
DEBUG_LEVEL Sets the ShoreSIP debugging
flags.
Recommend using level
0xe00.
diagdCommands Outputs full switch diagnostic
information.
dial_num_dump Displays information about
switch's off-system extension
configuration.