Specifications

Event Codes Switches
A
ShoreTel 14 Maintenance Guide 236
1306 Warning Switch <ShoreTel Voice Switch
Host Name>: Call was unable
to be completed due to
insufficient network bandwidth
between sites.
An attempted call exceeded
the limit on the number of
media streams allowed for
multiple sites.
May indicate the number of
media streams configured
for multiple-site calls cannot
handle the inter-site call
traffic.
From ShoreTel Director,
open the Site
Parameters page and
check the number of
media streams specified
for the "Other Number of
Media Streams for
Multi_Site" parameter.
Use the ShoreTel Site-
Link Configuration Guide
to determine the number
of media streams the
connection's bandwidth
can support.
If the bandwidth can
support more media
streams, raise the value
specified for the site.
Increasing the number
of media streams may
reduce sound quality for
multiple-site calls.
1307 Information Switch <ShoreTel Voice Switch
Host Name>: Trunk on port
<port number> forced out of
service.
Not reported in NT event
log.
1308 Warning Switch <ShoreTel Voice Switch
Host Name>: T1 is in %2
loopback mode.
The T1 switch is in a local or
payload loopback.
Your service provider is
performing diagnostic
tests.
1309 Information Switch <ShoreTel Voice Switch
Host Name>: T1 is out of %2
loopback mode.
Loopback on this switch
removed.
No action.
1310 Error Switch <ShoreTel Voice Switch
Host Name>: T1 framing error
<specific error>.
The T1 switch is
experiencing framing errors.
Check the cabling.
Contact your service
provider.
1311 Information Switch <ShoreTel Voice Switch
Host Name >: T1 framing ok.
Framing restored. No action.
1312 Error Switch <ShoreTel Voice Switch
Host Name>: T1 signal error
<specific error>.
T1 switch lost the T1 carrier
signal.
Check the cabling.
Contact your service
provider.
1313 Information Switch <ShoreTel Voice Switch
Host Name>: T1 signal ok.
T1 carrier signal restored. No action.
Table 54: Event Codes: Switches (Continued)
ID Severity Level Message Cause Action