Specifications

Voicemail-Enabled Switches CLI Commands
4
ShoreTel 14 Maintenance Guide 111
ifShow Displays the current configured network
parameters.
Not available on
Voicemail-enabled
Switch.
laa_debug_level Logs backup auto attendant signal flow.
lspConList Displays switch connectivity to other
switches.
lsp_debug_level Displays Location Service Protocol
messages that are exchanged between
switches.
Recommend using
level 4.
lsp_ping Tests the LSP UDP communication to the far
end switch for 100 iterations.
Tests LSP UDP communication to the switch
at 192.168.1.1, for 100 iterations (nominally 1
second). If only the IP address is supplied,
1000 iterations (nominally 10 seconds) is
used.
Example:
-> lsp_ping
"192.168.1.1",
100
lspTelList Displays local and remote contacts.
lspTelList 1 Displays detailed information about local
contacts.
lspTelList 2 Displays detailed information about remote
contacts.
mae_debug_level Logs BCA call flow information.
mailbox_debug_level Logs mailbox destination for a particular call.
memShow Shows current memory usage of the switch. Not available on
Voicemail-enabled
Switch.
mgcp_msg_debug Logs MGCP messages.
mgcp_trans_debug Logs MGCP transactions.
mohc_debug_level Prints diagnostic information for music on
hold calls when set to 1.
Valid settings are 0
and 1. Default is 0.
mpm_debug_mask – 0x40 Sets mpm debug flag to output Caller ID
information received on inbound calls.
mpm_debug_mask – 0x10 Displays detailed DTMF information.
mpm_debug_mask – -1 Displays detailed mpm information. Full
debug of inbound calls (CallerID, DTMF).
mscmd_verbose Prints diagnostic information for the media
commands sent from Switch board layer
when set to 1.
Main media
command verbose
variable. Default is
0.
Table 14: CLI Commands (Continued)
Command Description Notes