Specifications

Configuring Conference Bridges
5 – 2 ShoreTel, Inc.
Figure 5-1 Conference Bridges Main and Edit Pages
Enter parameters for the new server as described below and then click Save.
Parameters
The parameters on the Conference Bridges edit page are as follows:
For other parameters used in setting up conferencing, also see “Individual Users” on
page 10-19. For individual users whose Class of Service permits document sharing,
parameters need to be set to establish which conference server to use, a conference user
ID, and a conference password. The class of service also specifies the maximum
number of parties (3-6) that may be in a single Make Me conference. Also see “Setting
Call Control Options” on page 9-1 for information about the Make Me conference
timeout parameter that is set in case a participant does not end the call correctly.
Note that there may be up to six participants in a Make Me conference. Sufficient
conference ports must be reserved on a ShoreTel switch to support the maximum
simultaneous conferences you plan to support. For more information, refer to
“Configuring Switches” on page 6-1.
Name This is the name of a new or existing server.
Site This is the physical location of the server.
Fully Qualified Domain Name This is the server host name. If you enter the
server host name, Director resolves the IP
address for you when click Ping this Server.
You can also use the Ping this Server button to
test the connectivity between your client PC
and the new server.
Use HTTP (default port 80)
Use HTTPS (default port 443)
Override Default Port with NNNN
Specify the communication port to be used to
talk to the server.