Specifications

Setting Up System Parameters
2 – 10 ShoreTel, Inc.
Figure 2-8 SNMP Edit Page
Parameters
The parameters that appear on the SNMP edit page are as follows:
Community Strings This parameter lets you set the password for the Read-
Only (Get) and Read/Write (Get/Set) strings.
NOTE When no community string is enabled, the SNMP
agent is disabled.
• Read-Only (Get)—Set this string to enable read-only
SNMP access.
• Read/Write (Get/Set)—Set this string to enable
read-write SNMP access.
Trap Receivers This parameter lets you define up to five trap receivers to
receive traps from your ShoreGear voice switches. You
must specify an IP address for each trap. You can use any
IP address that has an SNMP trap listener (UDP Port
162) installed.