Specifications

Using ShoreWare Director
ShoreTel 7.5 Administration Guide 1 – 15
❑
Configure any ShoreTel Converged Conference Bridges in your system
from the Conference Bridges page. For more information, see the
ShoreWare Converged Conference Administration Guide. Then configure the
Conference Bridge server settings to enable document sharing and Make
Me conferencing (see “Adding a Conference Bridge Server” on page 5-1).
❑
Configure the ShoreTel Contact Center Solution in your system. For more
information, see the ShoreTel Contact Center Solution Administration Guide
and the ShoreTel Contact Center Planning and Installation Guide.
❑
Configure the ShoreWare System Monitor. For more information, see the
ShoreWare System Monitor Guide.
❑
Configure ShoreGear voice switches from the Switches page:
• Add each ShoreGear-120/24, ShoreGear 90, ShoreGear-60/12,
ShoreGear 50, ShoreGear-40/8, ShoreGear 220T1/T1A/E1 and
ShoreGear-T1/E1 voice switch.
• Provide a name and description and use the Find Switches button to
discover each voice switch on the network.
• Assign each switch to the proper site.
• Assign the configuration switches that manage the configuration
downloads to the IP phones. If you do not assign configuration
switches, the first two ShoreGear-120/24, ShoreGear-60/12, or
ShoreGear-40/8 switches you configure are automatically set as
configuration switches.
NOTE Your ShoreGear voice switches must have a valid IP address from a
DHCP server or from the BOOTP server on the ShoreWare server, or
an address statically configured from the maintenance port (24, T1,
and E1 only).
❑
Configure IP phones from the IP Phones link:
• Add IP phone ports to ShoreGear-120/24, ShoreGear 90, ShoreGear-
60/12, ShoreGear 50, ShoreGear-40/8, ShoreGear 220T1/T1A/E1 and
ShoreGear-T1/E1 voice switches supporting IP phones. For each port
you assign to IP phones, the switch supports five IP phones. For more
information, see Chapter 8, “Configuring IP Phones.”
• Set the boot parameters of the IP phones. ShoreTel IP phones are set to
find boot information from a DHCP server. If your installation has
other requirements, use the IP phone set-up menu to set server and
boot configuration parameters. For more information, see the ShoreTel
7.5 Planning and Installation Guide.
NOTE You can speed up the installation process by using the Office
Anywhere feature. For more information, see Chapter 8,
“Configuring IP Phones” as well as Appendix A, “Using Office
Anywhere.”