Specifications

Configuring Trunks
7 – 18 ShoreTel, Inc.
Individual Trunks
This section explains how to configure individual trunks once you have created the
associated trunk groups as described in the “Setting Up Trunks” section of this chapter.
To invoke t h e Trunks by Group page, click Trunks from the navigation frame, and
then click Individual Trunks. The Trunks by Group page appears, as shown in
Figure 7-16.
Figure 7-16 Trunks by Group Page
To select a trunk group, select a site from the Add new trunk at site drop-down list,
then select a trunk group from the In trunk group drop-down list, and click Go. The
trunks belonging to the selected trunk group appear. The columns in the Trunks by
Group page are as follows:
Name This is the name of an individual trunk in the group. Click an entry
in the Name column to invoke the Trunks edit page to edit the
individual trunk’s parameters.
Group This is the trunk group name. Click a group name to invoke the
Trunk Group edit page and edit the trunk group’s parameters.
Type This ID can range from 1 - 6 and corresponds to the trunk type
(e.g. analog DID, analog loop start, SIP, etc.)
Site This is the location of the trunk and can be the Headquarters
location or one of the remote locations.
Switch This is the IP host name of the ShoreGear voice switch to which the
individual trunk is connected.
Port/Channel This is the port number or channel to which the individual trunk is
connected.
SIP IP Address This IP address only applies to SIP trunks and corresponds to the
SIP end point device.