Specifications

Configuring Switches
ShoreTel 7.5 Administration Guide 6 – 47
NOTE The Find Switches feature will only find switches on the subnet
of the server. You must manually type in the IP and Ethernet
address for remote switches.
If your DHCP/ BOOTP server is not running, enter the switch’s IP
address manually in the IP Address field and enter the switch’s MAC
address in the Ethernet Address field.
Step 6 If the switch will be used to support IP phones, select the ports you
want to dedicate to IP support (ShoreGear-120/24, ShoreGear-60/12,
ShoreGear-40/8, or IPBX-24 only).
Step 7 If the switch will be used to support Make Me conferencing, select the
ports you want to dedicate to conferencing support. Reserve as many
ports as you need to support the maximum number of conferences you
will permit to occur simultaneously. For example, if you will allow two
three-way calls at the same time, reserve 6 ports. The minimum
number of ports that can be reserved for Make Me conferencing is four.
Step 8 If the switch will be used as a music-on-hold source, enable it by
clicking the Music Source check box.
Step 9 Click Save to save the configuration. The new switch is added to the
table in the Switches page. If you modified an existing switch
configuration, the table will be updated.
NOTE After you save your configuration, ports are allocated for the
switch, and a graphical view of the switch ports appears. When
you click a host name from the table in the Switches page, this
view appears automatically.