Specifications
Configuring Switches
ShoreTel 7.5 Administration Guide 6 – 29
IPBX-24, -12, -Teleworker, -T1, and -E1 Switches
This section describes the connectors and LEDs of the first generation of ShoreGear
voice switches. For information on second generation switches, see “SG-120/24, -60/
12, -40/8, and -T1 Switches” on page 6-17.
ShoreGear-24 Voice Switch
The ShoreGear-24 (IPBX-24) (Figure 6-10) supports 24 analog ports in a combination
of no more then 8 standard trunk ports and 16 analog telephone ports, up to 24. The
ShoreGear-24 interfaces to standard analog trunks using loop start or wink start
signaling, as well as to standard analog telephones, including CLASS feature phones
with Caller ID Name and Number, and Message Waiting.
The ShoreGear-24 can be configured to support up to 120 ShoreTel IP phones (five IP
phones per IP phone port). The ShoreGear-24 ports are configured for IP through the
Edit ShoreGear-24 page.
NOTE If you are installing IP phones in your system, you must assign sufficient
ShoreGear-24 ports to IP phone support before attempting to install and
configure IP phones.
NOTE The ShoreGear-24 does not support analog trunks outside the U.S. and Canada.
In addition, the ShoreGear-24 does not support Caller ID, Message Waiting, Fax,
and modems outside the U.S. and Canada.
The ShoreGear-24 LEDs are defined below. For information about the connectors,
please see the ShoreTel 7.5 Planning and Installation Guide.
Figure 6-10 ShoreGear-24 LEDs
Switch port
LEDs
Power LED
Network LEDs