Specifications

Page 3
SHOPSMITH 11” BANDSAW 555943
• Do not force the tool. It will do the job better
and safer at the rate for which it was de-
signed.
• Do not use a tool or accessory to do a job for
which it was not designed.
• Repair or replace damaged parts before fur-
ther use. If a strange noise or vibrations
develops, turn off and unplug the machine.
Correct the problem.
• Use clamps, fixtures and other devices to hold
workpieces when practical.
• Do not overreach. Keep proper footing and
balance at all times.
• Do not try to stop the tool by grabbing the
workpiece or any part of the tool. Turn off
the tool and let it come to a complete stop by
itself.
• Do not leave the tool running unattended.
• To discontinue operations, turn the power
off. Don’t leave the tool until it comes to a
complete stop.
• Avoid unintentional starting. Make sure the
switch is in the “Off” position before plugging
in or unplugging the tool.
• Keep tools sharp, clean and maintained ac-
cording to the instruction manual.
• Make your workshop childproof. Unplug
tools, use padlocks and master switches, and
remove starter keys.
• Keep children away. All visitors should stay
a safe distance from power tools and wear eye
and ear protection.
Eye Protection
• Always wear eye protection when you use
power tools. Use goggles, safety glasses or a
face shield to protect your eyes.
• Goggles completely surround and protect
your eyes. Many goggles will also fit over
regular glasses. Be sure your goggles fit
closely, but comfortably.
• Safety glasses don’t fog as easily as goggles
and can be worn all the time. Regular glasses
normally have only impact-resistant lenses.
They are not safety glasses.
• A face shield protects your entire face, not
just your eyes.
Safety Rules for the Bandsaw
WARNING
• Mount the Bandsaw only on the Shopsmith
Mark V, Power Station or Power Stand.
Mounting the Bandsaw on non-Shopsmith
machinery or using non-Shopsmith machin-
ery or using non-Shopsmith parts could cre-
ate a hazardous condition and will void your
warranty.
• Use only Shopsmith parts and accessories on
your Bandsaw.
• Do not remove stock or scraps until the blade
has stopped.
• Maintain proper adjustment of blade ten-
sion, blade guides and bearings.
• Keep the upper guide adjusted to a maximum
of 1/4" above the stock.
• Never reach close to the blade or under the
table while the tool is running.
• Hold stock firmly against the table.