Installation Sheet

ManualsBrandsShop All Mirabelle ManualsOtherMirabelle Optional 60" Tub Skirt

www.mirabelleproducts.com

ACRYLIC APRONS

MIRSK60 AND MIRSK72

Installation Instructions

Instructions d’installationt

Instrucciones de instalación

PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY before proceeding with the apron installation.

NOTE: Not compatible with all Mirabelle tubs. Check specication dimensions for compatibility

INSTALLATION (FIG.1)

1. With soaking tub or whirlpool in place, measure from the bottom of the tub lip to the nished oor surface. Subtract 1/8” from this dimension for

clearance. This adjusted dimension will be used to determine the proper apron height for your installation.

2. Lay apron face-up on at surface. Hook tape measure on stepped edge of apron near top and mark the adjusted dimension (identied in step 1) near

the bottom edge of apron. Repeat this several times across length of the apron. Draw a straight line at the marks on apron. This will be your cut line to

custom t the apron to your installation.

3. Apron can now be trimmed to the proper height by using a circular saw, jig saw or table saw with a medium toothed blade. To prevent scratching of

the acrylic surface, tape over area to be cut. Cut at a slow cutting speed and from acrylic side to prevent chipping the acrylic.

(FIG.1)

(FIG.2)

Finished Floor

Tub Lip

Stepped Edge

Summary of content (2 pages)

PAGE 1
ACRYLIC APRONS MIRSK60 AND MIRSK72 Installation Instructions Instructions d’installationt Instrucciones de instalación PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY before proceeding with the apron installation. NOTE: Not compatible with all Mirabelle tubs. Check specification dimensions for compatibility INSTALLATION (FIG.1) Finished Floor Tub Lip (FIG.1) 1. With soaking tub or whirlpool in place, measure from the bottom of the tub lip to the finished floor surface.
PAGE 2
Apron (FIG.3) 4. Insert the lip of trimmed apron up under tub edge, between the wooden blocks and the front tub lip. Check to see that you have cut the apron to the proper height. Remove apron. Plumb Bob (FIG.4) 5. Using a plumb bob or level, project front edge of tub lip down to floor surface and make a mark on floor. Repeat several times across front of tub. Draw a straight line at these marks. Line Block (FIG.5) 6.