Installation Guide

ManualsBrandsShop All Mirabelle ManualsOtherMirabelle 12.5 AMP In-Line Heater - For Use with Whirlpool and Total Massage Tubs

FIELD INSTALLABLE INLINE HEATER

INSTALLATION INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS

SEE THE BACK COVER OF THIS MANUAL FOR A LIST OF BATHTUBS THAT WILL ACCEPT

THIS HEATER.

Field Installable

Inline Heater

IMPORTANT SAFETY INSTRUCTIONS

- DO NOT DISCARD -

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS

READ AND FOLLOW ALL INSTRUCTIONS

For use with Mirabelle and PROFLO inline heaters

You should have received safety instructions with your hydro massage bathtub system. Please read

and follow them carefully. Those instructions should include the following warnings:

1. WARNING - Risk of Electrical Shock - Do not permit any electrical appliances (such as a light,

telephone, radio, or television) within ﬁve feet of the bathtub.

2. DANGER - To reduce the risk of injury, do not remove the suction cover from the bathtub.

3. To Reduce the Risk of Injury:

A. The water in your bathtub should not exceed 104° Fahrenheit. Lower water temperatures

are recommended for extended bathing (exceeding 10-15 minutes) and are deﬁnitely

recommended for young children.

Summary of content (5 pages)

PAGE 1
FIELD INSTALLABLE INLINE HEATER INSTALLATION INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SEE THE BACK COVER OF THIS MANUAL FOR A LIST OF BATHTUBS THAT WILL ACCEPT THIS HEATER.
PAGE 2
B. Pregnant or possibly pregnant women should consult a physician before using the hydro massage bathtub. Water temperatures in excess of 100º Fahrenheit are not recommended. C. The use of alcohol, drugs or medication before or during the use of the hydro massage bathtub may lead to unconsciousness with the possibility of drowning. Consult your physician before using the bathtub if you are using medication. D.
PAGE 3
Interference - Reset GFCI Note: Assure Heater is properly Grounded and Bonded Inspect Heater for Leaks or Moisture - Correct or Replace as Required GFCI TRIPS REPEATEDLY Defective Component - Replace Heater CIRCUIT BREAKER TRIPS Breaker Size Improper - Contact a qualified service technician. Heater Requires a DEDICATED Circuit -Assure No Other Appliances are on this Circuit 1.
PAGE 4
INDICATOR LIGHT: The light turns on when the heater is operating. PRESSURE/VACUUM SWITCH: The heater is equipped with a preset pressure or vacuum switch. The pump must be running with water flowing in the whirlpool to allow the heater to turn on. Note: Smaller fractional horsepower pumps may not activate the heater. Contact your dealer for troubleshooting procedure. 1. The heater must be connected only to a supply circuit that is protected by a ground-fault-circuitinterrupter (GFCI).
PAGE 5
ELECTRICAL CONNECTION INSTALLATION INSTRUCTIONS Install a separate 120 VoIt 15/20 Amp dedicated circuit with GFCI (Ground¬Fault-Circuit-Interruptor) protecting. With a No.8 solid copper wire, bond the heater and hydro massage bathtub pump to the homes electrical panel or approved local bonding point. A bonding lug has been provided on the heater. First you must locate the pump and Heater Ready fitting supplied with your hydro massage bathtub. Note: Photos are for illustration purposes only.