Safety Instructions

7
Burst Disk Overload Protection
The ShoeBox Compressor is equipped with a burst disk that can be
found behind the main air block. If the compressor sees pressures
greater than approximately 7500psi, the copper seal in this device will
blow out and vent the system. This burst disk is industry standard and
must be replaced after a venting incident. Use the same pressure
rated burst disk for replacement. Replacements are available from our
webstore: ShoeBoxCompressor.com under the ‘Order’ tab and then
under ‘Spare Parts’.
O-Rings and Back Check Valves
There are only 7 o-rings which are active seals in the compressor.
These o-rings are accessed by removing the cylinders. These o-rings
should only be replaced after watching the rebuild videos on the
website at Shoeboxcompressor.com. For technical support see go to
our forum at: Shoeboxcompressor.com/forum/
O-Ring Air Line Fittings
A new feature on the F10 is our own custom o-ring fittings on the air
lines. They are made to be user serviceable buy replacing the o-rings
if they start to leak. There is a permanent ferrule clamped on the air
line. Next comes a black steel washer that is removable so do not
leave it off. Next is the white urethane o-ring which is the same one