Safety Instructions

4
the front until it hits the stop. Make sure all covers are secure and in
place.
Running Compressor
Plug in the compressor to an electrical outlet supplying 110 volts AC
and push the black switch all the way to the right to start
compressor. The switch arm will spring back to center and is only
designed for momentary contact to the right to start the compressor.
This is much like a car ignition switch. The switch arm is on a spring
and will feel compliant to the touch. The compressor will start running.
Monitor pressure build up on the tanks gauge. If no gauge is present
on your tank, make sure to use a pressure gauge installed on the
rated fill hose to monitor pressure. The compressor has an electronic
shut off pressure switch set to 4500 psi. See adjustment section to
adjust shut off pressure. Once compressor shuts off when the tank
has reached the set pressure, remove the 125 psi compressor feed
hose and screw in the vent knob until you feel resistance. From there,
screw the vent knob about one additional turn just you hear the air
venting from the airline vent hole. Once the air has COMPLETELY
vented you may then disconnect your tank from the fill line. MAKE
SURE to unscrew the
vent knob back out or
your compressor will
leak when you turn it
on next time.