User manual

37
•
Clean the batteries charging contacts with a dry cloth.
When I press the CALL button, I hear a loud noise.
• The strange noise is caused by interference. Disconnect the mains power lead from
the back of the base unit, and then wait for 30 seconds before reconnecting it.
There is 'beep' sound while I am on a call.
• You may be going out of range of the base unit. Move closer, or your call may be cut
off.
• Check the Batteries Level symbol on the display. If it is low, recharge the batteries.
The Caller Display feature isn’t working.
• You need to subscribe to the Caller Display feature from your service provider.
• The caller may have withheld their number, or they may be calling from a network
that does not transmit the Caller ID (for example, it may be an international call).
The handset’s batteries are running low within an hour or two.
• Before you used the handset for the first time, you should have left it on the base unit
for up to 15 hours to charge the batteries fully.
• You may need to replace the batteries.
I cannot transfer a call.
•
Make sure the other handset is within range of the base unit, and is not busy on a call.
• Make sure you are keying in the correct number for the other handset.
No display on LCD screen.
•
Make sure the batteries have power.
I cannot register handset to base
• Make sure the number of handset registered to base is less than 4.
•
Check that the base unit is not near other electrical equipment, such as TV or
computer