User manual

31
While you are resetting the system, you should disconnect the telephone line cord from
the back of the base unit, so you won't be interrupted by incoming calls. To reset the
system without the PIN:
1. Disconnect the power lead from the back of the base unit
2. Press and hold the HANDSET LOCATOR button in the base unit, at the same
time connect the power lead into the back of base unit. Release the LOCATOR
button after you hear “beep” sound for five times. The IN USE light on base unit
lights during this whole process.
3. After 2~3 seconds, you can hear “beep” sound for two times again and the IN
USE light goes off;
4. Disconnect the power lead from base. Reconnect and you will hear a confirmation
tone from the base unit.

Contacts
Your list of contacts contains all Skype users as well as all landline phone users that you
have added. There is a limit to the number of entries you can make, but your contact list
can nevertheless hold hundreds of contacts.
To Access your Contacts List
It will take about 4 minutes to load the contact list for the first time if the number of your
contacts is above 200.
Press to access your contacts list in standby mode or
1. In standby mode, press to enter the main menu;
2. Press and to select Contacts;
3. Browse your contacts using , press to select one;
4. Press and to select your desired action (
Call, Send voicemail, View
profile, Advanced)
5. Under Advanced you can access more options (Rename, Remove, Block, Request
details, Add a contact ).
Note: If the Skype name in the contact list is more than 15 characters, it cannot be
displayed completely, and you have to view profile to check the whole name.
To Exchange Contact Details Request
You can send an authorization request to a Skype user
–
and if it is accepted, you can
see his or her online status.