Instruction manual
8
REMOTE CONTROL
Before making any connections to the SB-5548. Observe the following:
Ensure the mains voltage supply matches the label on the supplied plug- Pack (+/- 10%).
Ensure that the power switch is OFF.
Ensure that all system grounds (earth) are connected to a common point.
Avoid powering equipment within a system from multiple power sources that may be separated by large distances.
Connect all audio video sources and destination equipment.
Power up all source and destination audio-visual sources.
For each destination output select the appropriate input source by using The front panel input 1-8 select buttons. The supplied IR remote control.
Or through the RS-232 serial communications port.
Upon power up the switcher will return to its last used setting before Powered down.
REMOTE CONTROL
IR REMOTE CONTROL KEY : IR REMOTE : SW-5548C
1. & 2. SWITCH POWER ON or OFF:
Controller with a power ON and OFF
3. DESTINATION : 1 thru 8 OUTPUT SELECTION:
Press the destination button to select the output display channel.
4. SOURCE : 1 thru 8 INPUT SOURCE SELECTION:
Press input 1~8 sources with selection button
5. FUNCTION KEY:
ALL - function selection button
OFF - function selection button
RECALL - function selection button
DEMO or ENTER - function selection button
MEMORY - function selection button
LOCK - function selection button