Instruction manual

FRONT PANEL

12. FUNCTION KEY - MEMORY

The system can save up to 16 sets of switching routes, which are stored in local memory using Source keys 1 thru 16 or Destination

buttons 1 thru 16 as the memory location.

- Conﬁ gure desired matrices .

- Press MEMORY button.

- Press 1 thru 16 on either Source or Destination row.

- Press ENTER to ready memory location.

- Or press MEMORY again to cancel operation.

Operation completes.

Note: Operation will abort if no keys are dressed within 5 seconds.

13. FUNCTION KEY - LOCK

- Press and hold LOCK button for two seconds lock out the front panel (as shown on the left).

- Press and hold LOCK button for two seconds to enable the front panel (as shown on the right).

14. FUNCTION KEY - EDID

- Press EDID to begin setting up your EDID mode. Use source row buttons #1 and #2 to cycle thru the options. (Go to page 7 ~ 13

for EDID setup instruction.)