Instruction manual

ETHERNET SERIAL INTERFACE

ETHERNET SERIAL INTERFACE CONNECT A PC OR CONTROL SYSTEM. VERSION COMPATIBLE V2.0

For a complete list of commands, please reference external document extended Ethernet Protocol Instruction Manual.

ETHERNET SERIAL INTERFACE

Pin Ethernet Reference

1 TXOP TX +

2 TXON TX -

3 RXIP RX +

4NC

5NC

6 RXIN RX -

7NC

8 GND

ETHERNET TCP/IP PROTOCOL COMMANDS ( Ethernet / RS-232 Control driver V2.0.1 )

The ShinybowUSA switcher can be controlled via the TCP/IP serial control port to allow for interfacing to a PC, or similar third party control

system.

The serial communication parameters are 9600 baud, 8 bit, No Parity and 1 stop bit - this is often referred to as 9600 8N1.

When the unit recognizes a complete command it will perform the requested action - there is no delimiter character required.

Note :

Control the switcher

SPD : Speed

LINK : Ethernet link

RJ-45 Female 8P-8 Connector